24 yo trying out phimocure

"I'm 24 and just recently dicovered I have phimosis.
I'm sure I only have a mild case of phimosis in comparison to some of the guys here. Up until recently my foreskin would just move along the glans during sex and I never had any issue with it. Except for the last time I went to have sex and experienced a somewhat painful erection when the foreskin retracted behind the corona and got stuck (temporarily). After a quick googlein' that led me to these forums and in turn the Phimocure strecthing rings.

I've had my Phimocure kit for about a month now and have noticed some awesome results. The problem for me is that I'm already on the largest ring size for stretching and not noticing much improvement in retraction when erect. I no longer have painful erections, but the foreskin still gets a little hung up on the corona once it retracts back past the glans. When it comes to inserting the rings I've had some issues with it as they can be very difficult to have stay in place. I have found that if I use 2 rings inside my foreskin (smaller on the bottom, bigger on top) my phimotic ring will stay in the ridge of the top ring. Don't know why, but this seems to work possibly because my frenulum is shorter than it should be. Nothing a little stretching cant fix!

I still have a ways to go, the ring size phimocure goes up to is 30mm, and after some brief maths I found out I'll need a ring size about 44mm to have my foreskin move freely about the shaft. I've since put an order in for some silicone flesh tunnels to help me reach my goal size. My results so far are encouraging, can't believe I ever considered circumcision as a cure for my situation. "

My daily regimen consists of manual stretching every morning after my shower and then again at night before I go to bed. After my morning stretches (stretching the phimotic ring for 1min, then my frenulum for 1min, 3 minute break, repeat 3 or 4 times) I then insert the rings (30mm against glans, 28mm on top - currently) and wear them for the rest of the day. I'm at a bit of stall when it comes to progressing, as I don't yet have any rings bigger than 30mm. I have some on order and should be back to actually stretching with the rings in a couple of weeks. 

I was going to try and explain my insertion method for the rings, but its hard to explain and as I wrote it out, it got to be quite confusing. I'll try to get around to taking some pictures of the insertion steps I take. Doesn't take me very long at all any more. 5 minutes tops."

Source: http://www.network54.com/Forum/244184/thread/1389052845/last-1389891527/On+the+road+to+success  January 2014